Home
Product Reviews Accessories Support Multimedia Where to Buy
High-quality, competitively priced R/C products and accessories

Alligator Tours
Atlantic
Bristol Bay
Mini Alligator Tours
Mini Rio
Mini Thunder
Mini Wildcat
Miss Vegas Deuce
Minimono
Motley Crew
Paradise
Reef Racer 2
Rio 51Z
SuperVee 27R
Top Speed 3
UL-1 Superior
Vela
VS1
Wildcat EP

GrimRacer Accessories

Promotions

Top Speed 2 (AQUB0001-0004)
Tech Note

Posted July 29, 2005

On page 7 of the Top Speed 2 instruction manual (version 1.0), please disregard all references to the 7/32" (5.5 mm) drill bit. The proper size drill bit for drilling the holes for the brass threaded inserts is 3/16" (5 mm) or 13/64".

Please replace page 7 with this update:

PDF Top Speed 2 - AQUB0001-0004 (36K)


If you have drilled holes in the transom for the brass threaded inserts you will need to do the following:

  • Drill all four (4) holes out to 3/8" (10 mm).

  • Cut four (4) pieces of 3/8" (10 mm) dowel to 3/8" (10 mm), these will be used to plug the holes.

  • Place epoxy on the segments of 3/8" (10 mm) dowel and insert them into the holes. Wait until the epoxy has fully cured before proceeding.

  • Tape the appropriate template for the engine that are using in place on the transom. Mark and drill four pilot holes with a 1/8" (3 mm) drill bit.

  • Remove the template and use a 3/16" (5 mm) or 13/64" drill bit to increase the size of the hole.

If you have any further questions regarding this procedure, you should contact Hobby Services at (217) 398-0007 or Product Support at (217) 398-8970. Thank you for your continued interest in AquaCraft models!

GOOD LUCK AND GREAT BOATING!!


get adobe reader

Home   |   Product Reviews  |   Accessories  |   Product Brochures  |   Multimedia  |   Where To Buy

© 2005-2012 Hobbico®, Inc. All rights reserved. Terms of Use